Tuesday, 19 March 2013

Blasted.de Step by Step video guide for Elite Retaliator

This is one for all you modders out there. Those awesome people at Blasted.de have produced an awesomesauce step by step video guide on how to install the spring mod on a Nerf Elite Retaliator kit from Blasterparts.de. Much thanks to Klotzi on his video <3


5 comments:

  1. which is better, the orange mod works kits or this? they seem to be around the same price I think

    ReplyDelete
  2. 16 Euros comes out to be about 20.72 USD so its quite a bit more expensive... Also that plastic tube in the back does nothing. The plunger rod doesn't move around at all when it is primed... so I dunno...

    ReplyDelete
    Replies
    1. That part I believe reinforces the spring side of the casing to stop it from punching thru. It's a real job to prime and when it fires it sounds like its going to rip your arm off. LOL. I've done the mod myself with a kit I was sent.

      Delete
  3. If the Blaster is used with a stronger spring, the Plunger Rod DOES move, causing accidental firing after prinming. This "Guiding Shell" from Blasterparts.de does prevent that keeping the Rod in tight position. The stronger Catch Spring does the rest.

    ReplyDelete
  4. If the Blaster is used with a stronger spring, the Plunger Rod DOES move, causing accidental firing after prinming. This "Guiding Shell" from Blasterparts.de does prevent that keeping the Rod in tight position. The stronger Catch Spring does the rest.

    ReplyDelete